Lucent-technologies PortMaster Manual do Utilizador descarregar pdf (Página 141)

Configuring Dial-Out Connections 8-13

Setting Filters

This value is used only when the maximum number of ports is greater than one. The

default high-water mark is zero.

To set the high-water mark in bytes for a location, use the following command:

Command> set location Locname high_water Number

Setting Filters

You can attach input and output filters to each location. Filters must be defined in the

filter table before they can be added to the location table. For more information about

filters, see Chapter 9, “Configuring Filters.” When a filter is changed, all ports in use by

the location must be reset to have the changes take effect.

Note – If a matching filter name is not found in the filter table, this command is not

effective and all traffic is permitted.

Input Filters

Input filters cause all packets received from the interface to be evaluated against the

filter rule set. Only packets allowed by the filter are accepted.

To set an input filter for a location, use the following command:

Command> set location Locname ifilter Filtername

Output Filters

Output filters cause all packets going out to the interface to be evaluated against the

filter rule set. Only packets allowed by the filter are passed out to the interface.

To set an output filter for a location, use the following command:

Command> set location Locname ofilter Filtername

✍

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 363 364

Sem comentários

Lucent-technologies PortMaster Manual do Utilizador Página 141